Expensive cars come with reversing aids to make parking easier and for safety should a child or dog run behind the car.
You should have the same safety and convenience when you back up.
With that in mind, here is the reverse parking sensor
It takes about half an hour to fit yourself, just peel open powerful sticky pads on your two 2cm sensors, stick onto your bumper, connect clips to the wires going to your reversing lights and included leads to the unit.
DIY Instructions are included, with simple get you going and professional fitting options.
Once set up, the reverse parking sensor gives you an early warning system alerting you to the distance of objects behind your car.
At a safe distance of 1.5m 5ft there is silence and only an on light
Start reversing.
The reverse parking sensor watches and aids you.
There is nothing immediatly 1.5m to 1.0m 5.0-3.5ft behind you, a go ahead green light shows and there is a reassuring beep.
Should a bollard pop up suddenly to attack your car or a child run 1.0m to 0.6m 3.5 to 2ft behind your car there will be a more urgent beep beep and an amber warning light.
A life could have been saved.
Closer to an obstacle, 0.6m to 0.4m (2 to 1.3ft) and you hear repeated beeps and warning red light shows.
Nudged up neared than 0.4m (1.3ft) and there is a continuous tone with all lights flashing.
And you are comfortably parked.
The reverse parking sensor senses 80c up and down, so correctly fitted it will not be fooled by a low curb or a railing or fence above ground level.
A wide 190cm coverage is wider than most cars and avoids the common problem of accidently clipping scratching your car when reversing.
Reverse parking sensor includes 2 ultrasonic reverse parking sensor. 2 5m cables, teverse parking aids box with lights and sounds, fixings and instructions
